Addonics Technologies RTMPM6G Panduan Pengguna - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Penyimpanan Addonics Technologies RTMPM6G. Addonics Technologies RTMPM6G 4 halaman. Raid tower mini

Drive Installation

1.
Remove the three chassis screws from the back of the unit and remove the outer cover.
2.
Open the Drive Door up to four 3.5" hard drives or enclosures, connect each one to the power supply
and a SATA cable from the port multiplier. Refer to the Port Multiplier diagram in the Overview section.
3.
Secure each drive to the chassis.
4.
Close the Drive Door and replace the outer cover.
Port Multiplier Compatibility
The Port Multiplier in this unit will only work with a Port Multiplier aware SATA host adapter. Identify your host
controller and check with its hardware manufacturer if you are unsure. Addonics offers several Port Multiplier
aware host adapters.

Hot Swapping

This unit supports hot swapping (inserting or removing drives while the drives are running and connected to a
computer). The eSATA controller on the computer must also support hot swapping - be sure to confirm this
before attempting to insert or remove drives while the system is running. Also be sure to practice the
appropriate safe removal procedure before proceeding. Failure to practice safe removal procedures will
result in loss or corruption of data.
Phone: 408-453-6212
Email:
www.addonics.com/support/query/
2