Addonics Technologies RTMPM6G 사용자 설명서 - 페이지 3

{카테고리_이름} Addonics Technologies RTMPM6G에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Addonics Technologies RTMPM6G 4 페이지. Raid tower mini

Drive Installation

Remove the three chassis screws from the back of the unit and remove the outer cover.

Open the Drive Door up to four 3.5" hard drives or enclosures, connect each one to the power supply

and a SATA cable from the port multiplier. Refer to the Port Multiplier diagram in the Overview section.

Secure each drive to the chassis.

Close the Drive Door and replace the outer cover.

Port Multiplier Compatibility

The Port Multiplier in this unit will only work with a Port Multiplier aware SATA host adapter. Identify your host

controller and check with its hardware manufacturer if you are unsure. Addonics offers several Port Multiplier

aware host adapters.

This unit supports hot swapping (inserting or removing drives while the drives are running and connected to a

computer). The eSATA controller on the computer must also support hot swapping - be sure to confirm this

before attempting to insert or remove drives while the system is running. Also be sure to practice the

appropriate safe removal procedure before proceeding. Failure to practice safe removal procedures will

result in loss or corruption of data.

Phone: 408-453-6212

Email: