Addonics Technologies CFASTD4-2S Panduan Pengguna - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Duplikator Disk Addonics Technologies CFASTD4-2S. Addonics Technologies CFASTD4-2S 8 halaman. 1:11 duplicator

8-9. Auto Start Drive
This option is used to copy automatically once you inserted a HDD on target port.
Default is set at OFF, use the arrows to toggle.
8-10. Auto Start Timer
This option is used to set the period of time when the duplicator starts copying
automatically once you insert HDD on target port. Default is set at OFF, use the
arrows to choose time.
8-11. Tolerance Size
This option is used to set the tolerance in terms of percentage difference between
the source and target capacity. This is to ensure that when the target drive is
smaller than the source drive, the duplication process will not start.
8-12. BootTime Delay
This option is used to set boot delay time.

Troubleshooting

LCD
If the LCD display is blank after the device is turned on, check if the power
cable is properly connected and that the power supply is on.
Error Message
If an operation is manually terminated by pressing ESC while the system is running
a copy operation or hardware diagnostics, an error message will show up on the
LCD. This may lead to an illegal operation and cause the device to stop reminding.
If this happens, restart the device.
Source/Target
If the duplicator is unable to read the source or target please check that the data
and power cables are properly connected. When making a copy please make sure
that you set the source correctly.
Keys
If pressing the keys on the front panel produces no response from the system,
the keys may have malfunctioned.
Startup/Shutdown
Do not suddenly turn off the power while the system is performing an operation.
After shutting down normally, wait a moment (usually around 2 seconds) before
restarting the system so it can run self-diagnostics.
www.addonics.com
Technical Support (M-F 8:30am - 6:00pm PST)
Phone: 408-453-6212
Email: www.addonics.com/support/query/