AudioSource EQ 200 Panduan Pemilik - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Ekualiser Stereo AudioSource EQ 200. AudioSource EQ 200 12 halaman. Ten-band stereo graphic equalizer with spectrum analyzer display
Juga untuk AudioSource EQ 200: Panduan Pemilik (4 halaman), Panduan Pemilik (7 halaman), Panduan Pemilik (5 halaman)

Halaman Cetak

A Few Words About Graphic Equalizers

Thank you for choosing this AudioSource EQ 200 Graphic Equalizer. Used correctly, a Graphic

Equalizer is a powerful tool for very detailed control over the sound of your speakers, far more than

available from simple tone controls. With the EQ 200, you can enhance the sound of older recordings,

alter instrumental and vocal balance to suit your own tastes, make "Custom Equalized" recordings, and

a multitude of other uses. However, like any tool, excessive or incorrect adjustments can yield very

unpleasant results, and can overload your amplifiers and speakers. Improvement of sound quality,

particularly in the extreme bass and treble regions, is completely dependent upon the quality of the

other equipment you ark using in your system. Limited amplifier power and speakers with a limited

frequency range are the greatest barriers to achieving accurate, flat response. If you detect any distor-

tion in the bass or treble regions while boosting the EQ 200's sliders in these areas, back off immedi-

ately, as you are probably overtaxing either your amplifier or your speakers. Please read this manual

before use, and follow our suggestions and basic guidelines for the best sound.

Having said that, be assured that "good sound" is a relative thing... We all have different opinions

and tastes - The EQ 200 is designed to allow you to change the sound of your speakers to suit your own

musical choices. On the last page of this manual is a chart designed to show you the frequency content

and range for a variety of musical instruments. This chart will help you find the proper sliders to adjust

to achieve the desired results.

Basic Guidelines

Before adjusting the sliders, it is VERY IMPORTANT to clearly define your objectives. Without

this consideration before adjustment takes place, it will be very difficult to attain pleasing results.

Carefully listen to your system - ask yourself "What DON'T I like about the sound ?'I. If the answer is

"I want more Bass", you have two ways to accomplish this. Choice #l - Raise or "Boost" the sliders for

the lowest frequencies - on both channels - Left & Right. Choice #2 - lower or "Cut" the sliders on the

midrange and higher frequencies. The end result will be the same - You'll have more bass. Conversly, if

you'd like to hear more High Frequencies, you have two ways to accomplish this. #l -"Boost" the

sliders for the highest frequencies - on both channels - Left & Right. #2 - "Cut" the sliders of the

Midrange and Bass frequencies.

As you can see, there are a variety of ways to accomplish your objectives. Be aware that due to the

nature of all equalizer sliders, you will find that movement of any given slider will also have some

effect on the setting of the sliders adjacent to either side of it. Experiment - let your ears decide what

sounds best, but try to have a clear objective before you begin. One suggestion: avoid the "Boost-Boost

Syndrome"... avoid "Boosting" one frequency area too much, by "Cutting" another frequency area.

Don't jgst radically boost everything - it will add noise to the system, and overtax your other compo-

nents. Subtle, careful equalization will make a huge improvement in the overall sound of your system.

Enjoy your EQ 200, and if you have any questions, we are here to help. You can call AudioSource at

(800) HELP-l 15.