Contacta HLD9 Panduan Pengguna - Halaman 11

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Alat Bantu Dengar Contacta HLD9. Contacta HLD9 20 halaman. Hearing loop driver

Halaman Cetak
Secondary Driver Setup
MIC
CLIP
ACTIVE
PHTM
1. Confirm that the driver has been set to the SECONDARY mode
(see page 9). In this mode the driver follows the signal sent from the
primary or perimeter loop driver.
2. Connect an RJ45 cable between the expansion jack of the primary/
perimeter driver and the expansion jack on the secondary driver. Note:
If connected to a primary driver the driver outputs are 90 degrees out
of phase (for a phased array).
3. Nothing should be connected to the LINE or MIC input jacks on the
back of the secondary driver, and the input controls are not used on
the secondary driver apart from the drive level.
4. To enter adjustment mode push the DRIVE ( + and - ) buttons
simultaneously until the status light begins to flash on and off.
5. If setting up a phased array bring the current level up until the
DRIVE output lights from primary and secondary driver match, after
releasing the controls. Note: there are 8 button pushes between each
output light. In the phased array you want the same signal level in the
centre of the secondary loop as you have in the primary.
Assumes unit is properly connected and loop has continuity.
*
*
contacta HLD9
LINE
CLIP
ACTIVE
LOW SIG
To adjust drive when you have selected your mode press
DRIVE + and - together. The status LED will flash.
•
Press DRIVE + to increase level.
•
Press DRIVE - to reduce level.
Press DRIVE + and - together when adjustment complete
PERIMETER
PRIMARY
SECONDARY
MIC
CLIP
ACTIVE
PHTM
2.5
5
7.5
10
DRIVE
STATUS
POWER
contacta HLD9
MIC
LINE
contacta HLD9
CLIP
CLIP
ACTIVE
ACTIVE
LINE
PHTM
LOW SIG
CLIP
PERIMETER
ACTIVE
PRIMARY
LOW SIG
SECONDARY
2.5
2.5
5
7.5
10
PERIMETER
PRIMARY
DRIVE
SECONDARY
STATUS
POWER
11