Addonics Technologies HDUSI3TDR Panduan Pengguna - Halaman 12
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Duplikator Disk Addonics Technologies HDUSI3TDR. Addonics Technologies HDUSI3TDR 18 halaman. 1:11 hdd duplicator pro
Halaman Cetak
Press ENT to enter the following gure. The default is O . Use the Up and Down arrow keys to
choose 5 Sec-50 Sec.
Tolerance Size
This option is used to set the tolerance in terms of percentage di erence between
the source and target capacity. This is to ensure that when the target drive is
smaller than the source drive, the duplication process will not start.
Press ENT to enter the following gure. The default is O . Use the Up and Down arrow keys to
choose 1MB~100MB of source.
BootTime Delay
This option is used to to set boot delay time.
Press ENT to enter the following gure. The default is 5 sec. Use the Up and Down arrow keys to
choose 0~99 sec.
Quick Compare
This option is used to set the size of each comparison unit.
Press ENT to enter the following gure. The default is O . Use the Up and Down arrow keys to
choose 1 Byte/1K/10K/100K/1MB/10MB/100 Mbytes. (In order to improve the accuracy of pure
data can maintain the default settings.)
www.addonics.com
Auto Start Timer
O
10-11. Setup
Tolerance Size
Tolerance Size
1MB
10-12. Setup
BootTime Delay
BootTime Delay
5 sec
10-13. Setup
Quick Compare
Quick Compare
O
Technical Support (M-F 8:30am - 6:00pm PST)
Phone: 408-453-6212
Email: www.addonics.com/support/query/