Addonics Technologies HDUSI3TDR 사용자 설명서 - 페이지 12

{카테고리_이름} Addonics Technologies HDUSI3TDR에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Addonics Technologies HDUSI3TDR 18 페이지. 1:11 hdd duplicator pro

Press ENT to enter the following gure. The default is O . Use the Up and Down arrow keys to

choose 5 Sec-50 Sec.

Tolerance Size

This option is used to set the tolerance in terms of percentage di erence between

the source and target capacity. This is to ensure that when the target drive is

smaller than the source drive, the duplication process will not start.

Press ENT to enter the following gure. The default is O . Use the Up and Down arrow keys to

choose 1MB~100MB of source.

This option is used to to set boot delay time.

Press ENT to enter the following gure. The default is 5 sec. Use the Up and Down arrow keys to

choose 0~99 sec.

This option is used to set the size of each comparison unit.

Press ENT to enter the following gure. The default is O . Use the Up and Down arrow keys to

choose 1 Byte/1K/10K/100K/1MB/10MB/100 Mbytes. (In order to improve the accuracy of pure

data can maintain the default settings.)

www.addonics.com

Auto Start Timer

10-11. Setup

Tolerance Size

1MB

10-12. Setup

BootTime Delay

5 sec

10-13. Setup

Quick Compare

Technical Support (M-F 8:30am - 6:00pm PST)

Phone: 408-453-6212

Email: www.addonics.com/support/query/