Duratuf GG99 Manual Petunjuk Perakitan - Halaman 13
Jelajahi secara online atau unduh pdf Manual Petunjuk Perakitan untuk Penyimpanan Luar Ruangan Duratuf GG99. Duratuf GG99 16 halaman.
Halaman CetakROOF ASSEMBLY
SELECT:
10 x 1.350m Roof Sheets
2 x 1.350m 1 Pan Roof Sheet
2 x 2.725m Spouting
4 x 1.352m Barges
2 x 1.555m Ridge Cap
1 x 2.690m Ridge Beam
2 x 0.200m Jack Studs
8 x 75mm Screws
37 x 50mm Roofing Screws
66 x Rivets
38 x 50mm Clouts
STEP 1:
• Place the Ridge Beam on a level surface and use 2 x 75mm
screws to secure the Jack Studs to the underside of the Ridge
Beam, one at each end (fig. 1).
• Turn the Ridge Beam /Jack Stud assembly over and place it on
the timber Top Plate in a central position.
• Secure with 2 x 75mm screws through the top of the Jack Studs
into the Timber Top Plate (fig. 2).
• Check that the shed is sitting level and square and that the diago-
nal Top Plate measurements are the same.
STEP 2:
• Position the first Roof Sheet so that the top of the sheet is at the
centre of the Ridge Beam and the side of the sheet over hangs the
end of the Ridge Beam (fig .3). Using 1 x 50mm Clout, predrill and
nail through the rib into the top corner. Repeat above and nail the
lower corner ensuring 15mm overhang.
• Position the remaining front Roof Sheets and rivet them together as
shown.
• Nail the last sheet to the Ridge Beam and the Top Plate ensuring
the Roof Sheet overhangs the end of the Ridge Beam and the Top
Plate by 15mm.
•
Nail front Roof Sheets to Ridge Beam using 1 x 50mm clout per rib.
Screw to Top Plate using 1 x Roofing screw per rib (fig.4) ensuring
Ridge Beam and Top Plate are straight.
• Repeat with remaining roof sheets.
Pan
Rib
fig.4
IMPORTANT—FOR SHEDS WITH OPTIONAL CLEAR
ROOF PANEL
Assemble as below, making sure that the Clear Roof Sheets
overlap the standard roof sheets on both sides.
The Clear Roof Panel must be secured to the Top Plate and the
Ridge Beam. Pre drill and fasten with the 50mm roofing screws
provided..
12
RIDGE BEAM
JACK STUD
TOP PLATE
15mm
ROOF SHEET
RIDGE BEAM
JACK STUD
TOP PLATE
TOP PLATE
BACK WALL
BOTTOM PLATE
SIDE
WALL
RIDGE BEAM
FRONT WALL
TOP PLATE
BACK WALL
BOTTOM PLATE
SIDE
WALL
FRONT WALL
fig. 1
fig. 2
fig. 3
SIDE
WALL
SIDE
WALL