Duratuf GG99 조립 지침 매뉴얼 - 페이지 13

{카테고리_이름} Duratuf GG99에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Duratuf GG99 16 페이지.

페이지 인쇄

ROOF ASSEMBLY

SELECT:

10 x 1.350m Roof Sheets

2 x 1.350m 1 Pan Roof Sheet

2 x 2.725m Spouting

4 x 1.352m Barges

2 x 1.555m Ridge Cap

1 x 2.690m Ridge Beam

2 x 0.200m Jack Studs

8 x 75mm Screws

37 x 50mm Roofing Screws

66 x Rivets

38 x 50mm Clouts

STEP 1:

• Place the Ridge Beam on a level surface and use 2 x 75mm

screws to secure the Jack Studs to the underside of the Ridge

Beam, one at each end (fig. 1).

• Turn the Ridge Beam /Jack Stud assembly over and place it on

the timber Top Plate in a central position.

• Secure with 2 x 75mm screws through the top of the Jack Studs

into the Timber Top Plate (fig. 2).

• Check that the shed is sitting level and square and that the diago-

nal Top Plate measurements are the same.

STEP 2:

• Position the first Roof Sheet so that the top of the sheet is at the

centre of the Ridge Beam and the side of the sheet over hangs the

end of the Ridge Beam (fig .3). Using 1 x 50mm Clout, predrill and

nail through the rib into the top corner. Repeat above and nail the

lower corner ensuring 15mm overhang.

• Position the remaining front Roof Sheets and rivet them together as

shown.

• Nail the last sheet to the Ridge Beam and the Top Plate ensuring

the Roof Sheet overhangs the end of the Ridge Beam and the Top

Plate by 15mm.

•

Nail front Roof Sheets to Ridge Beam using 1 x 50mm clout per rib.

Screw to Top Plate using 1 x Roofing screw per rib (fig.4) ensuring

Ridge Beam and Top Plate are straight.

• Repeat with remaining roof sheets.

Pan

Rib

fig.4

IMPORTANT—FOR SHEDS WITH OPTIONAL CLEAR

ROOF PANEL

Assemble as below, making sure that the Clear Roof Sheets

overlap the standard roof sheets on both sides.

The Clear Roof Panel must be secured to the Top Plate and the

Ridge Beam. Pre drill and fasten with the 50mm roofing screws

provided..

RIDGE BEAM

JACK STUD

TOP PLATE

15mm

ROOF SHEET

RIDGE BEAM

JACK STUD

TOP PLATE

BACK WALL

BOTTOM PLATE

SIDE

WALL

RIDGE BEAM

FRONT WALL

TOP PLATE

BACK WALL

BOTTOM PLATE

SIDE

WALL

FRONT WALL

fig. 1

fig. 2

fig. 3

SIDE

WALL

SIDE

WALL