Duratuf KIWI SHEDS MK4A Manual Petunjuk Perakitan - Halaman 10
Jelajahi secara online atau unduh pdf Manual Petunjuk Perakitan untuk Tempat penampungan Duratuf KIWI SHEDS MK4A. Duratuf KIWI SHEDS MK4A 16 halaman. Base size 4.210mm x 2545mm
Halaman Cetak
Step 1: Position Right-hand Door Track (107) on the front wall with the
top of the track 7mm below the top of the timber frame. The left-
hand end should be 20mm to the right of centre of shed. (Ie Door
tracks will be 40mm apart)
Pre-drill a hole in the centre of the track and screw in place using
one 45mm door track screw. Remove ALL drill filings
Note: Ensure Door Track screws are screwed in horizontal
screwed hard into flashing. Protruding screw heads can
cause door rollers to bind on the screw heads.
Step 2: Hang right hand door in Door Track. At the right hand end of Door
Track, adjust up or down so that the Door hangs parallel with
shed. Fit one rivet at right hand end to hold in place. Repeat with
left hand end of track.
Note: Only use rivets at each end of track.
Step 3: Position left hand Door Track (107). Follow Steps 1 and 2 to hang
left hand Door. Where Door Tracks meet in the centre, adjust up
and down so that the Doors fit snuggly together, then rivet in
place.
Step 4: Remove Doors. Pre-drill and screw another 2 screws between
the centre screw and the rivets at each end of tracks(5 screws
per track). Screw tracks using 45mm door track screws.
Step 5: Clean out ALL drill filings. Also make sure the Wheels are
cleaned of drill filings. Re-hang Doors.
Fit outer door stops. Predrill a hole at each end of track, into rib of cladding
and screw outer door stops in using one Roofing screw per stop.
Fit inner door stops. Predrill a hole 45mm each side of doorway centre and
screw inner door stops in using one Roofing screw per stop.
Note– adjust
centre door stops left and right to ensure doors close
correctly.
Step 5: Bottom Door Guide: Slide the Door to open position. Place the
Door Guide (108) over the Guide Brackets on the door. Ensure
it is 20mm from centre of door opening.
Step 6: Lift the door guide up approximately 3mm so that the Door will
Slide freely. Pre-drill a hole through the door guide and the end
rib of the cladding and screw in place using a 45mm screw.
Step7:
Slide the door to the centre, ensuring that it slides freely. Pre-
drill and insert a screw in the other end of the Door Guide.
Check that the Door is not binding in the middle then pre-drill
and fix with 3 more screws, one in the centre of the guide and
the other 2 evenly spaced between (5 screws per guide) into
the door step flashing and rib. Repeat with 2nd door.
Note:
For sheds with Raised Base Plate option the Door Step Flash-
ing will protrude down past the Bottom Plate.
Attach Door Guide with rivets.
MK4A DOORS
and
MK4A DOORS
10
Centre of Doorway
45mm
Centre of
Doorway
CLADDING
DOOR
GUIDE BRACKET
DOOR
GUIDE
7mm
BOT-
PLATE