Duratuf KIWI SHEDS MK4A 조립 지침 매뉴얼 - 페이지 10

{카테고리_이름} Duratuf KIWI SHEDS MK4A에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Duratuf KIWI SHEDS MK4A 16 페이지. Base size 4.210mm x 2545mm

페이지 인쇄

Step 1: Position Right-hand Door Track (107) on the front wall with the

top of the track 7mm below the top of the timber frame. The left-

hand end should be 20mm to the right of centre of shed. (Ie Door

tracks will be 40mm apart)

Pre-drill a hole in the centre of the track and screw in place using

one 45mm door track screw. Remove ALL drill filings

Note: Ensure Door Track screws are screwed in horizontal

screwed hard into flashing. Protruding screw heads can

cause door rollers to bind on the screw heads.

Step 2: Hang right hand door in Door Track. At the right hand end of Door

Track, adjust up or down so that the Door hangs parallel with

shed. Fit one rivet at right hand end to hold in place. Repeat with

left hand end of track.

Note: Only use rivets at each end of track.

Step 3: Position left hand Door Track (107). Follow Steps 1 and 2 to hang

left hand Door. Where Door Tracks meet in the centre, adjust up

and down so that the Doors fit snuggly together, then rivet in

place.

Step 4: Remove Doors. Pre-drill and screw another 2 screws between

the centre screw and the rivets at each end of tracks(5 screws

per track). Screw tracks using 45mm door track screws.

Step 5: Clean out ALL drill filings. Also make sure the Wheels are

cleaned of drill filings. Re-hang Doors.

Fit outer door stops. Predrill a hole at each end of track, into rib of cladding

and screw outer door stops in using one Roofing screw per stop.

Fit inner door stops. Predrill a hole 45mm each side of doorway centre and

screw inner door stops in using one Roofing screw per stop.

Note– adjust

centre door stops left and right to ensure doors close

correctly.

Step 5: Bottom Door Guide: Slide the Door to open position. Place the

Door Guide (108) over the Guide Brackets on the door. Ensure

it is 20mm from centre of door opening.

Step 6: Lift the door guide up approximately 3mm so that the Door will

Slide freely. Pre-drill a hole through the door guide and the end

rib of the cladding and screw in place using a 45mm screw.

Step7:

Slide the door to the centre, ensuring that it slides freely. Pre-

drill and insert a screw in the other end of the Door Guide.

Check that the Door is not binding in the middle then pre-drill

and fix with 3 more screws, one in the centre of the guide and

the other 2 evenly spaced between (5 screws per guide) into

the door step flashing and rib. Repeat with 2nd door.

Note:

For sheds with Raised Base Plate option the Door Step Flash-

ing will protrude down past the Bottom Plate.

Attach Door Guide with rivets.

MK4A DOORS

and

MK4A DOORS

Centre of Doorway

45mm

Centre of

Doorway

CLADDING

DOOR

GUIDE BRACKET

DOOR

GUIDE

7mm

BOT-

PLATE