APlusLift HW-10KBP Panduan Pemasangan & Pengoperasian - Halaman 15
Jelajahi secara online atau unduh pdf Panduan Pemasangan & Pengoperasian untuk Sistem Pengangkatan APlusLift HW-10KBP. APlusLift HW-10KBP 20 halaman. 2-post floor plate car lift 10,000lb capacity
Juga untuk APlusLift HW-10KBP: Panduan Instalasi & Petunjuk Pengoperasian (16 halaman), Panduan Pemasangan & Pengoperasian (20 halaman)
Halaman Cetak
NEVER WORK UNDER OR NEAR THIS LIFT WITHOUT THE LOCKS BEING ENGAGED.
THE POWER UNIT IS NOT DESIGNED TO BE A LOADING-HOLDING DEVICE. NOT
USING THE LOCKS WILL RESULT IN A PREMATURE FAILURE TO THE CYLINDERS,
PUMP, AND/OR CABLES AND CAN CAUSE SERIOUS PROPERTY DAMAGE OR
PERSONAL INJURY! FAILURE TO HEED THIS WARNING WILL RESULT IN IMMEDIATE
TERMINATION OF YOUR WARRANTY!
FAILURE TO PERFORM THE DAILY PRE-OPERATIONAL CHECK CAN RESULT IN
EXPENSIVE PROPERTY DAMAGE, LOST PRODUCTION TIME, SERIOUS PERSONAL
INJURY, AND EVEN DEATH. THE SAFETY LATCH SYSTEM MUST BE CHECKED TO BE
WORKING PROPERLY BEFORE THE LIFT IS PUT TO USE.
NOTE: IT IS CUSTOMER'S OR USER'S RESPONSIBILITY TO MAINTAIN THE PROPER
TENSION ON THE EQUALIZER CABLES. ASK A QUALIFIED TECHNICIAN TO MAINTAIN
THE CABLE ADJUSTMENT AFTER THE LIFT IS INSTALLED.
IF AT ANY TIME YOU ARE NOT SURE HOW TO SAFELY OPERATE THE LIFT, STOP
USING THE LIFT AND CALL YOUR DISTRIBUTOR FOR ASSISTANCE.
Lubrication. Lubricate all nylon block corners inside each column with heavy duty
bearing grease before the first operation and once every six months. Lubricate chains
every six months.
Anchor Bolts. Check anchor bolts daily in the first week of use. DO NOT use an
impact wrench. After the first week, check them monthly for the first six months.
Tighten the anchor bolts if necessary.
Concrete. Check concrete for stress cracks daily in the first two weeks of use. After
the first two weeks, check it monthly.
Bolts and Nuts. Check all bolts and nuts every six months.
Hydraulic Oil. The hydraulic oil should be changed once a year, along with cleaning
the suction filer.
Safety Tips
◦ Never allow unauthorized persons to operate lift. Thoroughly train new employees
in the use and care of lift.
◦ Be aware that the power unit operates at high pressure.
◦ Remove passengers before raising vehicle.
◦ Prohibit unauthorized persons from being in shop area while lift is in use.
◦ Total lift capacity is 10,000 lbs. @ 2,500 lbs per lifting pad. Do not exceed maximum
weight capacity of lift.
◦ Before lifting vehicle, walk around the lift and check for any objects that may
interfere with the operation of lift and safety latches such as tools, air hoses, and
shop equipment.
◦ When approaching the lift with a vehicle, make sure to place the center the vehicle
between the columns so that the tires will clear the swing arms easily.
◦ Slowly drive the vehicle between the columns. It is recommended to have someone
outside the vehicle guide the driver.
Safety
15