APlusLift HW-10KBP-A Panduan Pemasangan & Pengoperasian - Halaman 11
Jelajahi secara online atau unduh pdf Panduan Pemasangan & Pengoperasian untuk Mengangkat kolom APlusLift HW-10KBP-A. APlusLift HW-10KBP-A 20 halaman. 2-post floor plate car lift 10,000lb capacity
Halaman Cetak
Step 5 (Installing Swing Arms)
Locate the 4 swing arms and swing arm pins. Take one of the arms and insert it over
the hole in the carriage torsion tube. Line up the holes and insert the pin. Repeat for
the three other arms.
We recommend putting 3-stage arms on the front and 2-stage arms on the back when
the car lift is used asymmetrically. Details
Step 6 (Electrical Connection to Power Unit)
Warning: T
electrician to connect the power unit to a 220V power outlet. Please
protect each circuit with a time delay fuse or circuit breaker.
The car lift uses a 220V single phase power unit. The running amperage is 10A.
Recommend a 30A breaker and a 10-gauge wire.
For 220V single split phase with two hot wires:
◦ wire brown to hot 1
◦ wire blue to hot 2
◦ wire yellow/green to ground
For 220V power with one hot and one neutral wires:
◦ wire brown to hot
◦ wire blue to neutral
◦ wire yellow/green to ground
See the figure on the right for reference.
he wiring must comply with local code. Please find a certified
11