APlusLift HW-10KBP-A 설치 및 운영 매뉴얼 - 페이지 11

{카테고리_이름} APlusLift HW-10KBP-A에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. APlusLift HW-10KBP-A 20 페이지. 2-post floor plate car lift 10,000lb capacity

Step 5 (Installing Swing Arms)

 Locate the 4 swing arms and swing arm pins. Take one of the arms and insert it over

the hole in the carriage torsion tube. Line up the holes and insert the pin. Repeat for

the three other arms.

 We recommend putting 3-stage arms on the front and 2-stage arms on the back when

the car lift is used asymmetrically. Details

Step 6 (Electrical Connection to Power Unit)

 Warning: T

electrician to connect the power unit to a 220V power outlet. Please

protect each circuit with a time delay fuse or circuit breaker.

 The car lift uses a 220V single phase power unit. The running amperage is 10A.

Recommend a 30A breaker and a 10-gauge wire.

 For 220V single split phase with two hot wires:

◦ wire brown to hot 1

◦ wire blue to hot 2

◦ wire yellow/green to ground

 For 220V power with one hot and one neutral wires:

◦ wire brown to hot

◦ wire blue to neutral

◦ wire yellow/green to ground

 See the figure on the right for reference.

he wiring must comply with local code. Please find a certified