Apogee SS-120 Panduan Pemilik - Halaman 13

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Alat Ukur Apogee SS-120. Apogee SS-120 20 halaman. Spectroradiometer

zero, the device will take measurements as soon as data has been pulled from memory. If 'Save data to file' is checked, the

user will be prompted to enter a file name. If a previously created file is chosen, the data capture function will append new

data to the end of the file. A different file must be chosen for each sensor currently connected to Apogee Spectrovision. If

'Plot data to screen' is checked, the data capture function will plot the first ten measurements of the file specified during data

capture setup. If multiple sensors are connected and there are less than ten measurements in the first file, the next file will be

read from until a max of 10 measurements have been accumulated for plotting. The data capture mode may be canceled at

any time by hitting the 'Cancel' button. Any measurements made before hitting the 'Cancel' button will still be saved in the

files specified during setup.

Connect: This features connects to a sensor plugged in to the computers USB port. If more than one sensor is connected, the

user will select which sensor to connect to from a dropdown menu.

Disconnect: Disconnect from the device chosen from the dropdown menu.

Red/Far Red Setup: Displays a window in which the user can specify the wavelength ranges of the Red and Far Red

spectrums. The ratio R/RF (Red/Far Red) is displayed during Energy Flux Density and Photon Flux Density plot modes.

Exit: Close the application.

VIEW MENU

HELP MENU

TOOLBAR DESCRIPTIONS

Set dark reference: During continuous measurement mode, this function will take the data from the last scan and

save it as a dark reference to be used during both Relative and Reflectance/Transmittance plot modes. Otherwise,

the application will take a new measurement to be used as the dark reference. If multiple devices are connected, the dark

reference scan will apply only to the device selected in the toolbar.

Set light reference: During continuous measurement mode, this function will take the data from the last scan and

save it as a light reference to be used during Reflectance/Transmittance plot mode. Otherwise, the application will

Each option in this menu will switch the current plot mode to the one specified in the drop

down menu. If continuous measurement mode is active, the next measurement taken will take

on the new plot mode. Otherwise, a single measurement will be taken and plotted to the screen

in the new plot mode.

Jump to the help tab of the chosen subject.