Apogee Symphony I/O Petunjuk & Panduan - Halaman 3
Jelajahi secara online atau unduh pdf Petunjuk & Panduan untuk Peralatan Perekaman Apogee Symphony I/O. Apogee Symphony I/O 9 halaman.
Pro Tools Native-HD
(Using single PCI card- not to be confused with ProTools Native)
✴ Software Release 2.1 or later must be downloaded from Apogeedigital.com and
installed. Following installation restart your computer.
✴ Power off Symphony I/O.
✴ Connect Symphony I/O to port 1 of Native-HD card.
✴ Power up unit. Set Symphony I/O to "Pro Tools HD" Audio Interface Mode (hold in
the right encoder to check and change if you need to)
✴ Verify that the Symphony I/O is clocked to internal and displays "INT" on the front-
panel.
✴ Launch Pro Tools (you should hear relays clicking from the Symphony I/O and the
exclamation mark icon on the front-panel should go away) and open the "hardware
setup"... click "default" just to double-check that all the i/o show up.
NOTE: Native-HD is compatible with ProTools 9 Intel Mac Pros only.
© Copyright 2011, Apogee Electronics.
The information in this document is confidential and proprietary. Redistribution without consent is strictly prohibited.
3