Apogee 10545 Petunjuk Manual - Halaman 4

Jelajahi secara online atau unduh pdf Petunjuk Manual untuk Mainan Apogee 10545. Apogee 10545 8 halaman. 1.9" ebay kit for aerotech rockets

Halaman Cetak

Sled Assembly Continued...

9. Place the smaller of the disks, "B1" on

the "E2" end of the sled and slide it up until it

stops. Now apply a small amount of wood glue

to the outside surface of the "B1" disk. Then

take your larger disk "B2" and quickly slide it

up against "B1" (Use the image on the right for

reference). Immediately wipe off any glue that

oozes out of the pieces on the outside of the

disks. Now apply a fillet of wood glue to where

the sled meets the disks and let dry.

10. For the opposite side of the sled: Re-

move the disk shapes "A1 & A2" from the

wood kit and remove the excess pieces inside

them with a screwdriver or pencil. Place the

smaller disk "A1" on the "E1" side of the sled

first. Then place the larger disk "A2" on after it.

Dab a small amount of wood glue between the

2 disk and then press them together. DO NOT

GLUE THESE DISKS TO THE SLED. Once

they begin to dry make sure to pull the disks

off the end of the sled and set aside for now.

*Wipe off any excess glue that oozes out along

the outside edges.

11. Temporarily insert the assembled sled

into the Tube Coupler Part "F" (Included in

the Aerotech Kit) and rotate the coupler to

align your switch hole with the sled. Then, mark

the side/edge of the sled through the hole.

12. Remove the sled from the coupler. Align

the switch button with the mark you made in

the prior step and thick super glue it to the sled

using thick super glue.

*Be very careful not to glue the switch

button itself or the inside of the switch. This

may permanently damage the switch and

prevent it from working properly.

*You may need shorten the wire lengths by

cutting and re-stripping the ends.

13. Take your Altimeter "N" and align it with

the corresponding holes on the Sled "E". The

PerfectFlite StratoLogger CF altimeter will align

with the holes spaced farther apart and the

Altus Metrum EasyMini altimeter with the holes

that are closer together.

Page 4

Apply the wood

glue here before

pressing the disk

together

Press both disks

onto the edge of the

sled and remove

after they are

together

Marker line

Step 9

Step 10

Step 11

Step 12

Step 13