- ページ 4
おもちゃ Apogee 10545のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Apogee 10545 8 ページ。 1.9" ebay kit for aerotech rockets
ページを印刷するSled Assembly Continued...
9. Place the smaller of the disks, "B1" on
the "E2" end of the sled and slide it up until it
stops. Now apply a small amount of wood glue
to the outside surface of the "B1" disk. Then
take your larger disk "B2" and quickly slide it
up against "B1" (Use the image on the right for
reference). Immediately wipe off any glue that
oozes out of the pieces on the outside of the
disks. Now apply a fillet of wood glue to where
the sled meets the disks and let dry.
10. For the opposite side of the sled: Re-
move the disk shapes "A1 & A2" from the
wood kit and remove the excess pieces inside
them with a screwdriver or pencil. Place the
smaller disk "A1" on the "E1" side of the sled
first. Then place the larger disk "A2" on after it.
Dab a small amount of wood glue between the
2 disk and then press them together. DO NOT
GLUE THESE DISKS TO THE SLED. Once
they begin to dry make sure to pull the disks
off the end of the sled and set aside for now.
*Wipe off any excess glue that oozes out along
the outside edges.
11. Temporarily insert the assembled sled
into the Tube Coupler Part "F" (Included in
the Aerotech Kit) and rotate the coupler to
align your switch hole with the sled. Then, mark
the side/edge of the sled through the hole.
12. Remove the sled from the coupler. Align
the switch button with the mark you made in
the prior step and thick super glue it to the sled
using thick super glue.
*Be very careful not to glue the switch
button itself or the inside of the switch. This
may permanently damage the switch and
prevent it from working properly.
*You may need shorten the wire lengths by
cutting and re-stripping the ends.
13. Take your Altimeter "N" and align it with
the corresponding holes on the Sled "E". The
PerfectFlite StratoLogger CF altimeter will align
with the holes spaced farther apart and the
Altus Metrum EasyMini altimeter with the holes
that are closer together.
Page 4
Apply the wood
glue here before
pressing the disk
together
Press both disks
onto the edge of the
sled and remove
after they are
together
Marker line
Step 9
Step 10
Step 11
Step 12
Step 13