Apollo Sprayers PRECISION-6 Buku Petunjuk - Halaman 12
Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Penyemprot Cat Apollo Sprayers PRECISION-6. Apollo Sprayers PRECISION-6 18 halaman. Auto turbine
Halaman Cetak8 Turbine Maintenance and Cleaning
Always unplug your turbine from the main electrical supply before doing any maintenance or
repairs.
After Each Use:
Your Apollo turbine system requires very little maintenance. The turbine motor has sealed bearings that are lubricated for
life. The only maintenance that you will need to perform is checking, cleaning and replacing your filters and pre-filters as
required. You should check your filters every 10 hours and replace as necessary. It is very important that your motor has cool, clean
air to operate efficiently. If you maintain your filters and prefilters well, you will enjoy many years of long service from your
turbine motor.
NOTICE
Always use genuine Apollo filters and pre-filters. Other types of filters and pre-filters may
prevent proper air flow to the motor, resulting in premature motor failure and voiding your
warranty.
8.1 Pre-Filter Maintenance
We recommend that you remove your pre-filters after each use. To remove the pre-filters: push your finger between the filter
and pre-filter until you can curl it up and pull the pre-filter off, rotating your finger around the pre-filter as you pull. Do not pull
hard as you will break the glue line on the pre-filter. Make sure you check both pre-filters as they can get dirty at different
intervals. If they appear to be a little dirty or clogged, you can wash them out using a mild soap and warm water. If they are
not cleanable you need to install new pre-filters.
To reinstall the pre-filters, hold one in both hands and apply the top first, moving your fingers around the inside as you slide it
back over the filter cartridge from top to bottom. NEVER operate your turbine without both filters and pre-filters installed and
clean.
Page 12