Duren 321240 Buku Petunjuk - Halaman 6

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Penyemprot Cat Duren 321240. Duren 321240 13 halaman. Electric hvlp turbine spray gun system

Halaman Cetak

321240

Instruction Manual

the paint is correct. This also aids comparison with existing paint work.

Applying pressure to the trigger will start the spraying. To obtain a greater flow of paint, turn the fluid output con-

trol anti-clockwise. Turning it clockwise will reduce the paint flow. Be aware that adjusting this control also

altered the spray pattern. A poor pattern will concentrate the spray towards the centre of the pattern, giving a

lumpy blotchy finish. A good pattern will evenly distribute the paint throughout the pattern.

To get best results, keep your spraygun level and at 90

200-300mm from the surface and spray evenly from side to side or up and down. Spraying at an angle will lead

to paint runs. Use smooth, even strokes. When spraygun large areas, use a criss-cross pattern as shown in Fig.

Never start or stop the gun whilst it is aimed at the workpiece. Too slow a pass will give a thin and patchy coat

whilst too slow a pass will result in a heavy coat. Apply one coat at a time and observe manufacturers drying

times before applying the next coat or finishing/polishing. Do not tip the gun more that 45

Fig. 1

Uneven finish created by arcing

Fig. 2

Nozzle Positions

Tall Narrow Jet

Vertical Surfaces

Flat Narrow Jet

Horizontal Surfaces

Duren Tools

T: 01582 484875 E: [email protected]

www.duren.co.uk

to the surface at all times (see Fig.1). Keep the nozzle

Keep trigger pressure and passing

speed consistant

Round Jet

Corners & Edges

Hard to Reach Areas

100 - 250mm

Incorrect Setting

Ineffective or no spray

pattern