Duren 321240 Інструкція з експлуатації - Сторінка 6
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Фарборозпилювач Duren 321240. Duren 321240 13 сторінок. Electric hvlp turbine spray gun system
Друкувати сторінку321240
Instruction Manual
the paint is correct. This also aids comparison with existing paint work.
Applying pressure to the trigger will start the spraying. To obtain a greater flow of paint, turn the fluid output con-
trol anti-clockwise. Turning it clockwise will reduce the paint flow. Be aware that adjusting this control also
altered the spray pattern. A poor pattern will concentrate the spray towards the centre of the pattern, giving a
lumpy blotchy finish. A good pattern will evenly distribute the paint throughout the pattern.
To get best results, keep your spraygun level and at 90
200-300mm from the surface and spray evenly from side to side or up and down. Spraying at an angle will lead
to paint runs. Use smooth, even strokes. When spraygun large areas, use a criss-cross pattern as shown in Fig.
2.
Never start or stop the gun whilst it is aimed at the workpiece. Too slow a pass will give a thin and patchy coat
whilst too slow a pass will result in a heavy coat. Apply one coat at a time and observe manufacturers drying
times before applying the next coat or finishing/polishing. Do not tip the gun more that 45
Fig. 1
Uneven finish created by arcing
Fig. 2
Nozzle Positions
Tall Narrow Jet
Vertical Surfaces
Flat Narrow Jet
Horizontal Surfaces
Duren Tools
T: 01582 484875 E: [email protected]
www.duren.co.uk
to the surface at all times (see Fig.1). Keep the nozzle
o
Keep trigger pressure and passing
speed consistant
Round Jet
Corners & Edges
Hard to Reach Areas
.
o
R
100 - 250mm
Incorrect Setting
Ineffective or no spray
pattern