DURKOPP ADLER 867 Petunjuk Manual - Halaman 13

Jelajahi secara online atau unduh pdf Petunjuk Manual untuk Aksesori Mesin Jahit DURKOPP ADLER 867. DURKOPP ADLER 867 16 halaman. Remaining thread monitor
Juga untuk DURKOPP ADLER 867: Petunjuk Manual (16 halaman), Petunjuk (4 halaman), Petunjuk Manual (8 halaman), Petunjuk Tambahan (18 halaman), Petunjuk Tambahan (20 halaman)

Halaman Cetak

Anbauanleitung des Restfadenwächters

Instructions for fitting remaining thread monitor

3.3

Screwing on and connecting the valve

Ausgabe/Edition:

10.2006

für div. Bausätze (siehe Pkt 1.1)

for var. kits (see section 1.1)

–

Pre-assemble the valve 1, make sure to mount the sealing

washer properly.

–

Screw on the valve 1 to the valve rail, for this purpose remove

the valve unit.

–

Screw on the valve unit again.

–

Connect the hose from the light barrier to the valve. If you are

intending to use both light barriers, left and right, connect the

hose using the 'Y' junction 2.

–

Attach the hose and the cable to the oil return line hose and

to the shaft of the knee lever with the clamps.

–

Connect electrically the solenoid valve to the valve circuit

board

- in case of extreme soiling X22 (3), PIN 1/7/8 (+)

and PIN 4 (FL)

- in case of moderate soiling X22 (3), PIN 1/7/8 (+)

and PIN 2 (FA)

Printed in Federal Republic of Germany

(X22)

Teile-Nr./ Part-No.:

0791 867702

Blatt:

von

Sheet: 13

from 16