DURKOPP ADLER 867 사용 설명서 - 페이지 13

{카테고리_이름} DURKOPP ADLER 867에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DURKOPP ADLER 867 16 페이지. Remaining thread monitor
DURKOPP ADLER 867에 대해서도 마찬가지입니다: 사용 설명서 (16 페이지), 지침 (4 페이지), 사용 설명서 (8 페이지), 추가 지침 (18 페이지), 추가 지침 (20 페이지)

페이지 인쇄

Anbauanleitung des Restfadenwächters

Instructions for fitting remaining thread monitor

3.3

Screwing on and connecting the valve

Ausgabe/Edition:

10.2006

für div. Bausätze (siehe Pkt 1.1)

for var. kits (see section 1.1)

–

Pre-assemble the valve 1, make sure to mount the sealing

washer properly.

–

Screw on the valve 1 to the valve rail, for this purpose remove

the valve unit.

–

Screw on the valve unit again.

–

Connect the hose from the light barrier to the valve. If you are

intending to use both light barriers, left and right, connect the

hose using the 'Y' junction 2.

–

Attach the hose and the cable to the oil return line hose and

to the shaft of the knee lever with the clamps.

–

Connect electrically the solenoid valve to the valve circuit

board

- in case of extreme soiling X22 (3), PIN 1/7/8 (+)

and PIN 4 (FL)

- in case of moderate soiling X22 (3), PIN 1/7/8 (+)

and PIN 2 (FA)

Printed in Federal Republic of Germany

(X22)

Teile-Nr./ Part-No.:

0791 867702

Blatt:

von

Sheet: 13

from 16