DURKOPP ADLER 867 사용 설명서 - 페이지 11

{카테고리_이름} DURKOPP ADLER 867에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DURKOPP ADLER 867 16 페이지. Remaining thread monitor
DURKOPP ADLER 867에 대해서도 마찬가지입니다: 사용 설명서 (16 페이지), 지침 (4 페이지), 사용 설명서 (8 페이지), 추가 지침 (18 페이지), 추가 지침 (20 페이지)

페이지 인쇄

Anbauanleitung des Restfadenwächters

Instructions for fitting remaining thread monitor

Mounting the thread monitor

3.1 Replacing the counter-knife and the bobbin case, screwing the light barrier

3.2 Mounting the control unit and the valve

Ausgabe/Edition:

10.2006

für div. Bausätze (siehe Pkt 1.1)

for var. kits (see section 1.1)

Caution Danger of injury !

Turn off the main switch.

Replace the thread monitor only with the sewing machine

switched off.

–

Replace the "old" bobbin case against the "new" one.

–

Screw on the pre-assembled support 2, using the screw 1

and/or 3.

Note:

In general, the front edge of the light barrier should be

parallel to the front edge of the support 2.

–

Connect the hose 4 for the blower.

–

Set the position of the light barrier in a way that its beam goes

through the slit of the bobbin case and can be reflected back

by the bobbin surface again.

–

Put the spacers 6 (4x) in the remaining thread monitor

support plate and put on the printed circuit board 5.

–

Connect the cable to the circuit board of the thread monitor

7 = valve circuit board

8 = for the light barrier of the left needle

9 = for the light barrier of the right needle

6 (4x)

Printed in Federal Republic of Germany

Teile-Nr./ Part-No.:

0791 867702

Blatt:

von

Sheet: 11

from 16