DURKOPP ADLER 867 Petunjuk Tambahan - Halaman 9

Jelajahi secara online atau unduh pdf Petunjuk Tambahan untuk Aksesori Mesin Jahit DURKOPP ADLER 867. DURKOPP ADLER 867 20 halaman. Remaining thread monitor
Juga untuk DURKOPP ADLER 867: Petunjuk Manual (16 halaman), Petunjuk (4 halaman), Petunjuk Manual (16 halaman), Petunjuk Manual (8 halaman), Petunjuk Tambahan (18 halaman)

Halaman Cetak

Assembling the remaining thread monitor

4. Set the position of the remaining thread monitor (1) so that the light

2.2 Connecting the remaining thread monitor

2.2.1 Connecting the remaining thread monitor on Classic

Fig. 2: Connecting the remaining thread monitor on Classic machines (1)

(1) - Remaining thread monitor carrier plate

(2) - Circuit board

To connect the remaining thread monitor:

1. Insert spacer (3) into the holes of the remaining thread monitor carrier

2. Attach the circuit board (2).

3. Connect the cables to the circuit board (2):

Additional Instructions 867/867-M PREMIUM - 00.0 - 07/2018

beam hits the reflective surface of the bobbin through the slot in the

bobbin case.

machines

①

②

③

plate (1).

• A = Valve circuit board

• B = Light barrier, left needle

• C = Light barrier, right needle

(3) - Spacer