4iiii PM100 Panduan Memulai Cepat - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Alat Ukur 4iiii PM100. 4iiii PM100 9 halaman. Power meter
Juga untuk 4iiii PM100: Panduan Memulai Cepat (2 halaman)

Halaman Cetak

1.2.4 Marking Install Location

With the Precision

pod fixed onto the crank arm as shown

in section 1.2.2, place a small mark on your crank using a

pencil or permanent marker adjacent to the center mark

on the pod. This is use to mark the location of the pod for

installation using the provided epoxy adhesive.

2. Pod Installation

2.1 Install Location

Prior to installing the Precision

arm, ensure the pod has the necessary clearance for the

bicycle as shown in igure 1.2, in section 1. Once a suitable lo-

cation for the pod has been found, mark the install location

as shown in section 1.2.4.

2.2 Preparing Crank Surface

Before the Precision

pod can be adhered to the crank

arm, the crank arm surface must be sanded and thoroughly

cleaned.

Do not open or mix the adhesive pack until

you are ready to apply the adhesive for in-

stallation – do not use the adhesive if it has

been opened for more than 5 minutes.

Figure 1.7

power meter on your crank

Figure 2.1

2.2.2 Clean Crank Arm

Thoroughly clean the crank arm with soap and water to

remove all dust and residue from sanding. Allow the crank

arm to fully dry before adhering the pod.

Do not attempt to dry the crank arm with

paper towel or a cloth that may leave lint

or other particles on your crank. To reduce

drying time, you may use a lint free shop

towel to dry the crank surface.

2.3 Adhering the Pod

Before adhering the pod, ensure the following items are

readily accessible:

• Precision

pod

• Precision

install band

• Precision

install tool

• Cleaning wipes (2x)

• Epoxy adhesive packs

• Adhesive applicator

• Clean printer paper

Do not open or mix the adhesive pack until you

are ready to apply the adhesive for installation

– do not use the adhesive if it has been opened

and/or mixed for more than 5 minutes.

Only perform the pod installation in tempera-

tures above 20°C or 68°F – doing so will not

allow the adhesive to cure properly and will

impact the performance and reliability of the

power meter.

2.3.1 Prepare Adhesive

Tear open the two epoxy adhesive packets squeeze the ad-

hesive onto a clean piece of printer paper. Mix the adhesive

thoroughly with the adhesive applicator.