4iiii PM100 Snelstarthandleiding - Pagina 5
Blader online of download pdf Snelstarthandleiding voor {categorie_naam} 4iiii PM100. 4iiii PM100 9 pagina's. Power meter
Ook voor 4iiii PM100: Snelstarthandleiding (2 pagina's)
Pagina afdrukken
1.2.4 Marking Install Location
With the Precision
pod fixed onto the crank arm as shown
TM
in section 1.2.2, place a small mark on your crank using a
pencil or permanent marker adjacent to the center mark
on the pod. This is use to mark the location of the pod for
installation using the provided epoxy adhesive.
2. Pod Installation
2.1 Install Location
Prior to installing the Precision
TM
arm, ensure the pod has the necessary clearance for the
bicycle as shown in igure 1.2, in section 1. Once a suitable lo-
cation for the pod has been found, mark the install location
as shown in section 1.2.4.
2.2 Preparing Crank Surface
Before the Precision
pod can be adhered to the crank
TM
arm, the crank arm surface must be sanded and thoroughly
cleaned.
Do not open or mix the adhesive pack until
!
you are ready to apply the adhesive for in-
stallation – do not use the adhesive if it has
been opened for more than 5 minutes.
8
Figure 1.7
power meter on your crank
Figure 2.1
2.2.2 Clean Crank Arm
Thoroughly clean the crank arm with soap and water to
remove all dust and residue from sanding. Allow the crank
arm to fully dry before adhering the pod.
Do not attempt to dry the crank arm with
!
paper towel or a cloth that may leave lint
or other particles on your crank. To reduce
drying time, you may use a lint free shop
towel to dry the crank surface.
2.3 Adhering the Pod
Before adhering the pod, ensure the following items are
readily accessible:
• Precision
pod
TM
• Precision
install band
TM
• Precision
install tool
TM
• Cleaning wipes (2x)
• Epoxy adhesive packs
• Adhesive applicator
• Clean printer paper
Do not open or mix the adhesive pack until you
!
are ready to apply the adhesive for installation
– do not use the adhesive if it has been opened
and/or mixed for more than 5 minutes.
Only perform the pod installation in tempera-
!
tures above 20°C or 68°F – doing so will not
allow the adhesive to cure properly and will
impact the performance and reliability of the
power meter.
2.3.1 Prepare Adhesive
Tear open the two epoxy adhesive packets squeeze the ad-
hesive onto a clean piece of printer paper. Mix the adhesive
thoroughly with the adhesive applicator.
9