Durston Tools 1312 Petunjuk Manual - Halaman 3

Jelajahi secara online atau unduh pdf Petunjuk Manual untuk Alat Listrik Durston Tools 1312. Durston Tools 1312 12 halaman.

These instructions contain very important safety information.

Please read them carefully before use.

The Quad Ringer is manufactured to help you to mass product jump rings using

non-ferrous jewellers' metals like silver, copper, brass and gold. These instructions

are for using non-ferrous materials. The Quad Ringer is used with a flex shat

machine and Foredom no. 30 style handpiece. Excellent results can be achieved

for wire diameters in the range 0.8 to 1.5 mm. Wire diameters beyond this range

may be possible once you become more experienced with your ringer.

The supplied mandrels allow you to produce coils between 2.5mm to 12.0mm

inner diameter. The coil holder allows coil lengths of up to 100mm in length.

You are advised to practice on copper wire before committing to full length coils

of precious metals such as silver and gold. This will confirm that your set up is

correct. It is also good practice to cut short test coils of new sizes before

committing to full length coils.

For best results use fully annealed (dead soft) wire, but good results can be

achieved using harder tempers of silver, gold filled and solid gold wires with

practice. The thicker the wire, the more important that the wire be annealed.