Durston Tools 1312 Petunjuk Manual - Halaman 5

Jelajahi secara online atau unduh pdf Petunjuk Manual untuk Alat Listrik Durston Tools 1312. Durston Tools 1312 12 halaman.

Preparing the Blade Holder

It is very important that the blade turns in the correct direction when cutting the coil. Failure to follow

these instructions will result in poor results and could be hazardous.

The arrow on the saw blade must point in the

directions shown when assembling the blade

holder. Once the blade holder has been assembled,

place into your Foredom H30 handpiece.

Safety: Do not connect it to your flexshaft yet.

Slide the handpiece into the handpiece holder, with

the blade going in last.

Place the coil holder lid over the blade. Ensure that

the coil holder lid is pressed to the edge of the

handpiece holder and the blade is in the centre of

the slit in the coil holder lid. Tighten the grub screw

to hold the handpiece in the handpiece holder. Do

not over tighten, a 3mm allen key/wrench is

required.

Note the direction of the blade when in use and the

direction of the saw teeth.