Elsema iS2000 Panduan Pengguna - Halaman 2
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pembuka Gerbang Elsema iS2000. Elsema iS2000 7 halaman. High speed sliding gate
opener
elsema’s eclipse
control card with gds operator
Juga untuk Elsema iS2000: Panduan Pengguna (8 halaman)
Place operator in correct position (Pinion wheel to be
parallel to the gate and stepped out to allow for width
of rack once it is mounted onto the gate frame). Mark
out fixings and fix operator to the concrete pad.
Once the rack is fixed move the gate and sight the
rack moving over the pinion wheel, check that most of
the pinion wheel meshes with the rack. Make sure
rack runs freely over the pinion wheel, any tights
spots should be corrected by adjusting the rack height.
Check the operator is firmly bolted down to the
concrete pad.
Connect required P.E Beams.
Limit switches can be used in 2 different configurations
1. Limit switch initiates ramp down and the gate stops as per ramp down time.
2. Limit switch initiates slow speed and the gate stops on slow speed overload after hitting the end
stoppers.
Follow the on screen instructions to commission the gate.
Quick start instructions
Fix rack to the gate frame keeping 1mm-2mm clearance
between the rack teeth and Pinion wheel
Ensure stops are installed on the gate for the fully closed and
fully open positions.
2