Elsema iS250 Panduan Pengguna - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pembuka Gerbang Elsema iS250. Elsema iS250 12 halaman. Swing gate opener

C. INSTALLATION OF REAR BRACKET

Step 1 : Calculate the position of the rear bracket by using the details in Figure 1 and Graph 2. This Figure

and Graph establishes dimensions

you can also use values for greater than 90˚ from Graph 2. Please note that the fully closed position of

the gate should be where the operator is fully extended minus 10mm.

Step 2 : Before securing the rear bracket to the pillar check the front bracket can be welded to a solid point

on the gate leaf. Do not fix the front bracket yet.

• Fully close the gate.

• Connect the rear and front brackets to the motor.

• Hold the rear bracket onto the pillar with the calculated A and B values.

• Move the motor in a vertical direction until the fixing zone is in a solid area of the gate leaf for

the front bracket.

Step 3 : Then fix the rear bracket to the pillar.

•

Make sure the rear brackets straight edge is facing each other when mounted.

•

If the 2 gate leafs have different speeds, check the

both the gate leafs.

and the

and

for gate 1 should be the same as

iS250/iS250D/iS250Solar SWING GATE OPENER MANUAL

maximum opening angle

and

dimensions. They should be same for

. If your gate is opening 90˚

and

for gate 2