Elsner 70512 Instalasi dan Penyesuaian - Halaman 11

Jelajahi secara online atau unduh pdf Instalasi dan Penyesuaian untuk Pengontrol Elsner 70512. Elsner 70512 20 halaman. Multifunctional actuators

2.5. Instructions for assembly and operational

start-up.

Never expose actuators to water (e.g. rain) or dust. This can damage the electronics.

You must not

exceed a relative air humidity of 80%. Avoid condensation.

After the auxiliary voltage has been applied, the device will enter an initialisation phase

lasting a few seconds. During this phase no information can be received or sent via the

bus.

For KNX devices with safety functions (e.g. wind or rain blocks), it is important to set

up periodical monitoring of the safety objects. The optimal ratio is 1:3 (example: if the

weather station sends a value every 5 minutes, the actuator must be configured for a

monitoring period of 15 minutes).

The device is supplied with the bus address 15.15.255. You can program another ad-

dress into the ETS by overwriting the 15.15.255 address or by teaching via the pro-

gramming button.

After use, the device must be disposed of or recycled in accordance with the legal reg-

ulations. Do not dispose of it with the household waste!

Actuators KNX S1R-UP • Version: 27.05.2020 • from software version 4.00, ETS programme version 4.00 •

Technical changes and errors excepted.

Addressing of the device at the bus