CB2 MONOLITH Manual Petunjuk Perakitan - Halaman 6
Jelajahi secara online atau unduh pdf Manual Petunjuk Perakitan untuk Perabotan Dalam Ruangan CB2 MONOLITH. CB2 MONOLITH 6 halaman. Wardrobe
Juga untuk CB2 MONOLITH: Manual Petunjuk Perakitan (13 halaman)
Halaman Cetak
monolith
wall mounting assembly
large
screw
mounting
D
bracket
wall
strap
NOTE:
If you are unsure about your wall type or what
mounting method you should use, consult a
qualified professional or your local hardware store.
For added safety and stability, it is recommended that the wall mounting hardware be installed. For safe
mounting, it is essential to use wall anchors appropriate to your wall type (i.e. plaster, drywall, concrete,
etc.). Mount to wood studs whenever possible.
A) Attach 2 mounting brackets to top of unit using 2 small screws per bracket.
B) Determine the final location of unit. Mark position on the wall, approximately 2" below each mounting
brackets mounted to the back of the unit.
C) Drill a hole in the wall stud. If the wall stud is not available, drill a hole in the wall that is slightly smaller
in diameter than the anchor. Gently tap the plastic anchor until the flange of the anchor is flush with the
wall.
D) Attach the mounting brackets to the wall by inserting 2 large screws through each mounting
bracket and into the wall anchor in the wall.
E) Position the unit so the mounting bracket on the back edge is allowed with the wall bracket.
F) Lace one end of each wall strap through corresponding brackets, and into the other end of the strap.
G) Pull the straps tightly until secure.
Wall mounting assembly is now complete.
Made in Vietnam - r06
CABINET
mounting
bracket
C
plastic
anchor
A
small
screw
Customer Service 800.606.6252 | Latest instructions available at www.cb2.com
WALL
Page 6 of 6