CB2 MONOLITH 조립 지침 매뉴얼 - 페이지 6

{카테고리_이름} CB2 MONOLITH에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CB2 MONOLITH 6 페이지. Wardrobe
CB2 MONOLITH에 대해서도 마찬가지입니다: 조립 지침 매뉴얼 (13 페이지)

monolith

wall mounting assembly

large

screw

mounting

bracket

wall

strap

NOTE:

If you are unsure about your wall type or what

mounting method you should use, consult a

qualified professional or your local hardware store.

For added safety and stability, it is recommended that the wall mounting hardware be installed. For safe

mounting, it is essential to use wall anchors appropriate to your wall type (i.e. plaster, drywall, concrete,

etc.). Mount to wood studs whenever possible.

A) Attach 2 mounting brackets to top of unit using 2 small screws per bracket.

B) Determine the final location of unit. Mark position on the wall, approximately 2" below each mounting

brackets mounted to the back of the unit.

C) Drill a hole in the wall stud. If the wall stud is not available, drill a hole in the wall that is slightly smaller

in diameter than the anchor. Gently tap the plastic anchor until the flange of the anchor is flush with the

wall.

D) Attach the mounting brackets to the wall by inserting 2 large screws through each mounting

bracket and into the wall anchor in the wall.

E) Position the unit so the mounting bracket on the back edge is allowed with the wall bracket.

F) Lace one end of each wall strap through corresponding brackets, and into the other end of the strap.

G) Pull the straps tightly until secure.

Wall mounting assembly is now complete.

Made in Vietnam - r06

CABINET

mounting

bracket

plastic

anchor

small

screw

Customer Service 800.606.6252 | Latest instructions available at www.cb2.com

WALL

Page 6 of 6