4M Spy Science Panduan Pengguna

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Sistem Keamanan 4M Spy Science. 4M Spy Science 2 halaman. Intruder alarm

Halaman Cetak

CHOKING HAZARD

I N T R U D E R A L A R M

Not for Children under 3

A. SAFETY MESSAGES

1. Please read through this instructions before you start.

2. This kit is intended for age 8 and up.

3. Adults assistance and supervision required.

4. This kit contains small parts which may cause suffocation if misused.

5. Metal connection plate and wires may contain sharp points, adult assistance required in

assembling and bending.

6. Never touch the contacts inside the battery case to prevent possible short circuit.

B. USE OF BATTERY

1. Requires two "AA" batteries (Not included). We recommend alkaline batteries.

2. For optimum operation, always use fresh alkaline batteries.

3. Insert batteries according to the correct polarities.

4. Make sure that the supply terminals are not short circuited.

5. Do not leave batteries in the toy if it is not in use.

6. Remove empty batteries from the toy.

7. Do not recharge non-rechargeable batteries.

8. Rechargeable batteries should be removed from the toy before being charged (if removable).

9. Rechargeable batteries should only be charged under adult's supervision.

10. Do not mix old and new batteries.

11. Do not mix alkaline, standard (Carbon-Zinc) or rechargeable (Nickel-Cadmium) batteries.

12. Only use batteries of the same or equivalent type.

13. The toy should not be connected to more than the recommended number of power supplies.

C. CONTENTS

C2.

BATTERY HOLDER

C1.

PLASTIC INTRUDER ALARM CASE SET

WITH SWITCH AND

WITH COVER AND BASE PLATFORM

WIRES INSTALLED

C10.

C6.

CONNECTION

STRING, DOUBLE ADHESIVE

C8.

WALL MOUNT

PLATE (WITH METAL

TAPES AND DOOR PLATE

PLATES INSTALLED)

C9.

TRIGGER

C7.

TRIGGER PLATE

PLATE HOLDER

D. INSTRUCTIONS: ASSEMBLING THE ALARM CASE

WARNING

Small parts.

Install the buzzer (C3).

C3.

BUZZER WITH

WIRES INSTALLED

C4.

METAL PEGS

C5.

PLASTIC PEGS

OTHER ACCESSORIES:

Connect the wires from the

buzzer with that from the

connection plate. Match the

wires colours.

Install the connection

plate (C6).

Connect the wires from

battery holder with that

from the buzzer. Match the

wires colours.

Install battery holder (C2).

Install the cover to complete the alarm case

set.

Install the batteries. You may

now check if all connections

are correct by switching on

the switch button. The

buzzer should produce a

buzzing sound. After the

testing, switch it off.

QUESTION AND COMMENTS

We treasure you as a customer and your satisfaction

with this product is important to us. In case you have

any comments or questions, or you find any parts of

this kit missing or defective, please do not hesitate to

contact our distributor in your country, whose address

is printed on the package. You are also welcome to

Connect the wires from the

contact our marketing support team at Email:

connection plate with that

[email protected], Fax (852) 25911566, Tel (852)

from the battery holder.

28936241, Web site: WWW.4M-IND.COM

Match the wires colours.