Datapath VisionSC-DP2 Panduan Pengguna - Halaman 11
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Kartu PCI Datapath VisionSC-DP2. Datapath VisionSC-DP2 17 halaman. Audio and video capture card
Juga untuk Datapath VisionSC-DP2: Panduan Memulai Cepat (2 halaman)
Installing the Capture Card
You are likely to need a flat blade and /or a cross head screwdriver for the installation of the
VisionSC-DP2 card; it would be useful to have these to hand before you begin.
•
Power down the PC (including peripherals), switch off at the mains and disconnect all the cables
connected to the computer, noting the positions for accurate re-connection
•
Remove the PC cover
•
Locate a vacant PCI Express slot (x4 or higher) on the motherboard and remove the blanking plate
(retain all screws)
If you are in doubt consult your motherboard documentation to correctly identify a PCI Express slot. If
the card is forced into a 32 or 64 bit PCI or PCI-X slot it will be irreparably damaged when the system is
powered up and the warranty will be
Reconnect all cables to the PC then connect a DisplayPort cables (not supplied) distributing the video
source signal to a DisplayPort connectors on the VisionSC-DP2 capture card
•
Power up the PC and commence the software installation
How to Connect Input Sources
The VisionSC-DP2 card has two locking DisplayPort 1.2 connectors. See Fig. 1
When removing the DisplayPort cables from the VisionSC-DP2, ensure the release button is pressed on
the connector to allow the cable to release freely. (Fig. 2)
void.
Fig. 1
9