Datapath VisionSC-DP2 Kullanıcı Kılavuzu - Sayfa 11

PCI Kart Datapath VisionSC-DP2 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Datapath VisionSC-DP2 17 sayfaları. Audio and video capture card
Ayrıca Datapath VisionSC-DP2 için: Hızlı Başlangıç Kılavuzu (2 sayfalar)

Sayfayı Yazdır

Installing the Capture Card

You are likely to need a flat blade and /or a cross head screwdriver for the installation of the

VisionSC-DP2 card; it would be useful to have these to hand before you begin.

•

Power down the PC (including peripherals), switch off at the mains and disconnect all the cables

connected to the computer, noting the positions for accurate re-connection

•

Remove the PC cover

•

Locate a vacant PCI Express slot (x4 or higher) on the motherboard and remove the blanking plate

(retain all screws)

If you are in doubt consult your motherboard documentation to correctly identify a PCI Express slot. If

the card is forced into a 32 or 64 bit PCI or PCI-X slot it will be irreparably damaged when the system is

powered up and the warranty will be

Reconnect all cables to the PC then connect a DisplayPort cables (not supplied) distributing the video

source signal to a DisplayPort connectors on the VisionSC-DP2 capture card

•

Power up the PC and commence the software installation

How to Connect Input Sources

The VisionSC-DP2 card has two locking DisplayPort 1.2 connectors. See Fig. 1

When removing the DisplayPort cables from the VisionSC-DP2, ensure the release button is pressed on

the connector to allow the cable to release freely. (Fig. 2)

void.

Fig. 1