DV Signage VS-700 Catatan Aplikasi - Halaman 6

Jelajahi secara online atau unduh pdf Catatan Aplikasi untuk Beralih DV Signage VS-700. DV Signage VS-700 14 halaman. Video sync setup

NETCFG.INI and DVSYNC.INI setup

To enable video synchronization feature on VS-700, a special options are required to setup in

NETCFG.INI file. Below is the section to show how to configure a NETCFG.INI for master unit

and slave unit respectively.

Copy all video content on to "media" folder on USB flash drive.

Create a NETCFG.INI and place it in the "media" folder on the USB flash drive.

Update the video content and NETCFG.INI on to the Master unit (VS-700) through

USB update. (see VS-700 user guide)

The NETCFG.INI file contains some system and network settings. The following table

shows the major options required in Video synchronization.

Options in NETCFG.INI

IP_OVERWRITE

NETMASK

GATEWAY

DNS1

DNS2

NETSYNC_MASTER_MODE

NETSYNC_NUM_SLAVE

Below is an example of a NETCFG.INI file for "Master unit":

IP_OVERWRITE=1

IP=10.1.0.70

NETMASK=255.255.255.0

GATEWAY=10.1.0.1

NETSYNC_MASTER_MODE=1

NETSYNC_NUM_SLAVE=4

Note: All master and slave unit must in different static IP addresses.

Description

0 – Keep old IP address

1 – Use the new IP address

IP address

Subnet Mask Address

Gateway address

DNS1 address

DNS2 address

Master mode enable

(0=disable, 1=enable)

The total number of Slave unit in the

LAN.

Page 6 of 14