DVIGear WILDCAT DVI-7570 Panduan Pengguna - Halaman 9
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pemanjang DVIGear WILDCAT DVI-7570. DVIGear WILDCAT DVI-7570 14 halaman. 4k hdmi cat6 extender set
Halaman Cetak2 SPDIF Output: female TOSLINK connector; connect to an audio receiver.
3 Analog Stereo Line Out: female 3.5mm connector; connect to an
audio receiver.
WARNING 1: The CAT cable ports are designed to connect to compatible DVIGear Wildcat™
series products only. Do not connect any device to the CAT cable connector unless you are
sure it is compatible. Connecting incompatible devices with similar connectors may cause
harm to the devices.
WARNING 2: It is typical for the CAT cable receiver unit to operate at higher temperatures
than the transmitter unit. In order to ensure proper operation and long term reliability, care
must be taken to ensure airflow is not restricted in any way.
4.1
System Set-up
DVIGear HR™ HDMI Cable
CAT6A Cable
IR Control
Audio Output
Power Cable
DVI-7570-TX
HDMI Monitor Loop Output
HDMI Input
Blu-Ray Player
This HDMI extension system consists of a Transmitter unit (DVI-7570-TX) and a
Receiver unit (DVI-7570-RX). To connect this system, first remove power from
all devices (installing devices while powered may cause damage). Connect a
CAT6A twisted pair cable to the CAT OUT on the transmitter unit. Connect the
other end of the CAT6A twisted pair cable to the CAT IN on the receiver unit.
Connect an HDMI or DVI signal source to the HDMI IN port on the transmitter
Audio Output
IR Tx
* AC Power Adapter can be installed on either the Tx or Rx unit and automatically powers both devices.
DVI-7570-RX
(remotely powered by transmitter)
HDMI Output
12 VDC Power
Adapter*
3840 x 2160/60p: 30 meters (98 ft.)
3840 x 2160/30p: 70 meters (230 ft.)
POC Remote Power
-7-
Sound Bar
4K Television
(or Projector)
CAT6A Cable Distance
IR Rx