BENDIX Wingman FLR10 Panduan Petunjuk Instalasi - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Aksesori Mobil BENDIX Wingman FLR10. BENDIX Wingman FLR10 8 halaman. Radar changeover kits

Halaman Cetak

Cavity 2: CAN1_Hi

Cavity 3: CAN1_Lo

Cavity 8: Power

FIGuRe 2 - existing wire designations and the dt06-6s Cavities to use in the new ConneCtor

Gain access to the radar; where necessary, remove

the bumper from the vehicle by following the vehicle

manufacturer's instructions.

Remove the Bendix

1. Disconnect the wire harness from the Bendix

radar. Protect the connector and harness from damage.

2. Typically two (2) bolts are used to attach the bracket to

the vehicle. Remove and retain the bolts from the Radar

Assembly. (Inspect the bolts; replace corroded/damaged

bolts as necessary, using OEM-approved hardware.)

3. Remove the old radar assembly from the bracket and

save for core return.

Inspection

4. Inspect and clean all surfaces of the cross-member.

Any damage found that would affect the installation of

the new radar and bracket should be addressed before

continuing with the installation.

Preparing the Harness

5. See Figure 2. Record the wire colors used by the OEM.

for the locations of the existing speciality vehicle wire

harness in the spaces provided in Figure 2

6. Cut the existing wire harness 4 inches, or less, from the

connector. After verifying that the wire colors recorded

in step 5 above are correct, discard the connector.

7. Carefully review the Deutsch connector manufacturer's

instructions for stripping and crimping the wire into the

new connector before proceeding.

Deutsch ST06-6S Connector

FIGuRe 3 - ConneCtor Components

Record the wire

colors used

for the original

radar system

here Ô

Cavity 1: Ground

FLR10

Radar

™

Wedge Used with

Socket

Connector

Part

Not Used — Use Plug Supplied

Follow the manufacturer's directions in lieu of the

recommendations supplied here:

(a) Strip all four wires 0.250 to 0.312 inch.

FLR10

™

(b) Crimp the Deutsch socket part [0462-201-16141] on

each of the exposed wires. See Figure 4.

(from step 5) into cavity from the rear, following the wir-

ing colors recorded in Step 5. For the two locations not

being used, insert the [0413-217-1605] white sealing

plugs.

Listen for the audible (and tactile) "click", when the socket

seats correctly in the plug.

8. Insert the Deutsch W6S

the connector. See Figure 3.

9. Plug the assembled connector into the harness adapter

supplied.

Prepare the Bendix

10. Insert the three (3) new adjuster assemblies into the

bracket.

FIGuRe 4 - radar sensor adjusters installation

11. Insert the six (6) adjuster mounting screws into the

Plug

assembly. Using a Torx T20 driver, start every screw

into the assembly, then tighten them all to 30 in-lbs.

DT06-6S

Function

Cavity Designation

Ground

CAN1_Hi

CAN1_Lo

Power

locking wedge into the front of

™

FLR20

Radar and Bracket

™