dymax T17241 Panduan Pengguna - Halaman 12

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Peralatan Industri dymax T17241. dymax T17241 20 halaman. Digital syringe dispenser

SD-100 Digital Syringe Dispenser User Guide

Operating the System

Manual Mode

Manual mode allows the user to dispense for an unlimited amount of time by either

pressing down on the supplied foot pedal or pushing the SHOT button on the front of

the SD-100 unit. The material will continue to dispense for as long as the user is pushing

down on the foot pedal or pressing the SHOT button. As soon as either of these are

released, the dispensing will stop.

The unit will also count the amount of time you are dispensing during a cycle which may

be helpful in determining a time to be used when programming the timer mode. If you

need to adjust the decimal point to allow for the timer to show a higher or smaller

value, press the SET button then use the ▲ and ▼ to adjust the position.

Press the MODE button to cycle to Manual Mode.

Press the SHOT button or the foot pedal to start dispense. Release either to stop

dispense.

Timer Mode

The Timer Mode allows the user to dispense for a set period of time despite how long

the foot pedal is pressed.

For example: If you would like to set the dispenser to dispense for 1 second, follow the

instructions below.

Press the MODE button until the timer mode is selected.

Press the SET button. The first digit on the right side of the display will start

blinking.

Press the ◄ button twice. The third digit from the right on the digital display

should be blinking.

Press the ▲ button once to increase the value of this digit. To adjust the decimal

refer to page 15.

Press Exit/Mode to save as current setting.