GRDIAN Charger Plus Panduan Pengguna - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Peralatan Uji GRDIAN Charger Plus. GRDIAN Charger Plus 18 halaman. Hardwire kit

STEP 4: LINE AND LOAD SIDE

LINE AND LOAD SIDE

In this step we will be checking to see which

side of your constant and switched fuse is

line and draw.

With the add-a-fuse inserted, test the line

and load side with your multimeter. The

bottom left slot should read 12V while the

bottom right slot should read 0V.

HOW TO DETERMINE LINE AND LOAD SIDE

Turn on ONLY your vehicle's electrical system.

2. Set your multimeter to 20 DCV.

3. Remove either your constant or switched fuse. (You will repeat the steps for the other fuse)

4. Insert your add-a-fuse into the empty fuse slot.

5. With the black lead touching your ground point, test for line side by placing the

on the bottom left slot of your add-a-fuse. It should read 12V.

6. With the black lead touching your ground point, test for load side by placing the

on the bottom right slot of your add-a-fuse. It should read 0V.

7. If the above is the case, you have located the line side of your fuse and have placed your

add-a-fuse correctly. If not, remove and place the add-a-fuse in reverse. Repeat steps 6

& 7 to test. Test both slots again to make sure the left bottom slot reads 12V and the right

bottom slot reads 0V.

8. Repeat steps above for the other fuse.

red

lead

red

lead