Gage Bilt 1753 Manual Petunjuk Asli - Halaman 14

Jelajahi secara online atau unduh pdf Manual Petunjuk Asli untuk Peralatan Gage Bilt 1753. Gage Bilt 1753 20 halaman. Installation tool

Halaman Cetak
Gage Bilt 1753 Manual Petunjuk Asli
WARNING:
Disconnect tool from its power source before actuator removal or installation. Severe personal injury may occur if
power source is not disconnected.
CAUTION:
Actuator assembly-air (704130) can break if not careful.
CAUTION:
Do not over tighten actuator assembly-air (704130). Snug tighten only.
REMOVING ACTUATOR ASSEMBLY-AIR (704130)
1.
Remove actuator lever assembly (704343) including pin-slotted (400608) from handle assembly (722132).
2.
Insert a 5/8" open end wrench / adjustable wrench around actuator assembly-air (704130).
3.
Loosen the actuator assembly-air (704130).
4.
Remove wrench. Unthread and remove the actuator assembly-air (704130) with fingers from the handle
assembly (722132).
INSTALLING ACTUATOR ASSEMBLY-AIR (704130)
1.
Apply Teflon® tape onto threads of actuator assembly-air (704130) one to two wraps.
2.
Thread the actuator assembly-air (704130) all the way into handle assembly (722132) with fingers.
3.
Insert and turn 5/8" open end wrench / adjustable wrench and snug tight approximately 1/4-1/2 turn.
4.
Reinstall actuator lever assembly (704343) with pin-slotted (400608) to handle assembly (722132).
GB722 S/N: 1753 AND ABOVE
PLEASE CONTACT GAGE BILT FOR ALL OTHER SERIAL NUMBERS.
OVERHAUL
ACTUATOR ASSEMBLY-AIR
14
REV. 5/22