Gage Bilt 1753 Оригинальное руководство по эксплуатации - Страница 14
Просмотреть онлайн или скачать pdf Оригинальное руководство по эксплуатации для Инструменты Gage Bilt 1753. Gage Bilt 1753 20 страниц. Installation tool
Печатать страницу
WARNING:
Disconnect tool from its power source before actuator removal or installation. Severe personal injury may occur if
power source is not disconnected.
CAUTION:
Actuator assembly-air (704130) can break if not careful.
CAUTION:
Do not over tighten actuator assembly-air (704130). Snug tighten only.
REMOVING ACTUATOR ASSEMBLY-AIR (704130)
1.
Remove actuator lever assembly (704343) including pin-slotted (400608) from handle assembly (722132).
2.
Insert a 5/8" open end wrench / adjustable wrench around actuator assembly-air (704130).
3.
Loosen the actuator assembly-air (704130).
4.
Remove wrench. Unthread and remove the actuator assembly-air (704130) with fingers from the handle
assembly (722132).
INSTALLING ACTUATOR ASSEMBLY-AIR (704130)
1.
Apply Teflon® tape onto threads of actuator assembly-air (704130) one to two wraps.
2.
Thread the actuator assembly-air (704130) all the way into handle assembly (722132) with fingers.
3.
Insert and turn 5/8" open end wrench / adjustable wrench and snug tight approximately 1/4-1/2 turn.
4.
Reinstall actuator lever assembly (704343) with pin-slotted (400608) to handle assembly (722132).
GB722 S/N: 1753 AND ABOVE
PLEASE CONTACT GAGE BILT FOR ALL OTHER SERIAL NUMBERS.
OVERHAUL
ACTUATOR ASSEMBLY-AIR
14
REV. 5/22