Gage Bilt GB745SH Panduan Pengguna - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Peralatan Gage Bilt GB745SH. Gage Bilt GB745SH 14 halaman. Installation tool

Halaman Cetak
HEAD
Remove nose assembly from tool before attempting disassembly of head cylinder (745366).
Remove end cap (745816). Push against threaded end of piston (745310) to slide it out of head cylinder (745366). Be careful not to
damage threads or cause burrs on polished piston rod surface.
WARNING:
Dispose of Hydraulic Oil in accordance with applicable regulations.
The re-assembly sequence is the opposite of disassembly. (See Filling and Bleeding instructions.) Apply Loctite #242 and torque the
four socket-head cap screws (400061) uniformly to 40 inch lbs. to prevent leakage around the gasket.
753101 - NOSE FITTING
480124 - NUT
204304 - SWIVEL ASSEMBLY
401080 - BACK-UP RING
S/N: 1033 AND ABOVE
PLEASE CONTACT GAGE BILT FOR ALL OTHER SERIAL NUMBERS.
745366 - HEAD CYLINDER
401092 - BACK-UP RING
480101 - PINTAIL TUBE
480125 - RETAINING NUT STOP
403805 - O'RING
745305 - GLAND
S829 - O'RING
S832 - O'RING
745124 - GASKET
700326 - HANDLE-SPLIT
704312
ACTUATOR LEVER ASS'Y
704130 - AIR ACTUATOR ASSY
S1181 - BARBED FITTING
A-144 - HOSE CLAMP
204304 - SWIVEL ASSEMBLY (2)
(INCLUDES 401080 & 403764)
403764 - O'RING
745310 - PISTON
403815 - O'RING
401119 - BACK-UP RING
402482 - BUTTON HEAD SCREW (2)
S572 - STAT-O-SEAL (2)
A-261 - O'RING
704311 - AIR LINE
402482 - BUTT0N HEAD CAP SCREW
S572 - STAT-O-SEAL
10
756120 - DEFLECTOR
A-820 - O'RING
405889 - O'RING
403846 - O'RING
401119 - BACK-UP RING
A-663 - HANGER
400061 - SOCKET HEAD CAP SCREW
A-1282 - HYDRAULIC HOSE (2)
703561 - HOSE GUARD (NOT SHOWN)
S572 - STAT-O-SEAL
745303 - MANIFOLD - HANDLE
745816 - END CAP
401105 - BACK-UP RING
A-144 - HOSE CLAMP
S1181 - BARBED FITTING
402482
BUTT0N HEAD
CAP SCREW
7/12 REV. 8/14