Gage Bilt GB150 Manual Petunjuk Asli - Halaman 5

Jelajahi secara online atau unduh pdf Manual Petunjuk Asli untuk Alat Keling Gage Bilt GB150. Gage Bilt GB150 8 halaman. Hydraulic hand riveter
Juga untuk Gage Bilt GB150: Manual (4 halaman)

Halaman Cetak
Gage Bilt GB150 Manual Petunjuk Asli
WARNING:
DO NOT pump tool when spring is not in place. To retract tool with no spring: Bring handles together, push the
button with middle finger or free hand. Place thumb and first finger, of same hand, on front of protective shield
and force it to the full retracted position. Release button and handles.
WARNING:
Operator
WARNING:
It is required that eye protection, hearing protection and safety boots be worn at all times while handling this
equipment.
WARNING:
The users or the user's employer must assess specific risks that could be present as a result after each use
based on their application.
● Ensure there is adequate clearance for tool and operator's hands before proceeding. Keep fingers clear of any
moving parts. Keep fingers clear from fasteners and installed materials. Severe personal injury may result.
●
Ensure that there are no electrical cables, gas pipes, etc., which can cause a hazard if damaged by the tool.
WARNING:
Do not actuate fastener in the air. Personal injury from fastener ejecting may occur.
WARNING:
Do not use as a hammer.
WARNING:
Do not use in explosive atmosphere.
CAUTION:
Do not use beyond the design intent.
The Hydraulic system is sealed and oil should not be added. If the tool should be damaged and leaks oil, RETURN IT TO AN AUTHORIZED
SERVICE CENTER.
1. Place the jaws inside the collet (20323).
2. Place the collet (20323) into the end of spring (50304).
3. Place other end of the spring (50304) over the puller shaft and thread the collet (20323) onto the shaft hand tight until no threads
are showing.
4. Place the holder (10245) over assembly and hand tighten until threads do not show.
5. Choose a nose tip specific to your needs, (nose tips sold separate see chart below), and thread into the holder (10245) and hand
tighten. Reverse for disassembly. It may be necessary to pump tool out 2 or 3 strokes before nose tip can be entirely threaded
onto the holder (10245).
GAGE BILT : GB150 INSTALLATION TOOL
HOW TO SET-UP THE GB150
MUST
read and understand all warnings and cautions.
(With riveting assembly in place per diagram tool is ready to operate. See pg. 6).
*Nose tips not supplied with tool
*BLIND RIVET NOSE TIPS
PART NO.
SIZE
10231
3/32"
10232
1/8"
10425
5/32"-3/16"
10211
1/4"
Image may not reflect actual tool.
Rev. 10/22