Gage Bilt GB150 Manual Petunjuk Asli - Halaman 6

Jelajahi secara online atau unduh pdf Manual Petunjuk Asli untuk Alat Keling Gage Bilt GB150. Gage Bilt GB150 8 halaman. Hydraulic hand riveter
Juga untuk Gage Bilt GB150: Manual (4 halaman)

Halaman Cetak
Gage Bilt GB150 Manual Petunjuk Asli
WARNING:
DO NOT pump tool when spring is not in place. To retract tool with no spring: Bring handles together, push the
button with middle finger or free hand. Place thumb and first finger, of same hand, on front of protective shield
and force it to the full retracted position. Release button and handles.
WARNING:
Operator
WARNING:
It is required that eye protection, hearing protection and safety boots be worn at all times while handling this
equipment.
WARNING:
The users or the user's employer must assess specific risks that could be present as a result after each use
based on their application.
● Ensure there is adequate clearance for tool and operator's hands before proceeding. Keep fingers clear of any
moving parts. Keep fingers clear from fasteners and installed materials. Severe personal injury may result.
●
Ensure that there are no electrical cables, gas pipes, etc., which can cause a hazard if damaged by the tool.
WARNING:
Do not actuate fastener in the air. Personal injury from fastener ejecting may occur.
WARNING:
Do not use as a hammer.
WARNING:
Do not use in explosive atmosphere.
CAUTION:
Do not use beyond the design intent.
The Hydraulic system is sealed and oil should not be added. If the tool should be damaged and leaks oil, RETURN IT TO AN AUTHORIZED
SERVICE CENTER.
GAGE BILT : GB150 INSTALLATION TOOL
HOW TO USE THE GB150
MUST
read and understand all warnings and cautions.
1. Pump handles 3 or 4 times, holding them together fully on last pump.
Push the button while handles are together and nose assembly will
retract.
2. Place fastener stem into the nose tip and insert fastener into desired hole.
Note: Always hold tool so pulling head is perpendicular to surface of material in
which fastener is being installed. Exert firm pressure against fastener during
installation.
3. Pump handles to install fastener. If more than 10 full pumps are required,
re-grip fastener by pushing button and bringing handles together, slide
tool up on fastener stem and finish installing.
4. After stem breaks, push button and bring handles together, point nose
tip down and fastener stem will fall out, or can be removed by hand.
5. Repeat steps 1-4.
Images may not reflect actual tool or fastener
Blind Fasteners
Rev. 10/22