Airwell-Fedders Remote Controller Panduan Ilustrasi - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Ilustrasi untuk Kontrol Jarak Jauh Airwell-Fedders Remote Controller. Airwell-Fedders Remote Controller 7 halaman. Room air conditioner

Halaman Cetak
Setting the clock
Before you start operating the air conditioner,
set the clock of the remote controller using
the procedures given in this section. The
clock panel on the remote controller will
display the time regardless of whether the
air conditioner is in use or not.
Initial Setting or the Clock
After batteries are inserted in the remote
controller, the clock panel will display "12:00".
Press and hold the CLOCK button for 3nds,
the time begin to flash.
1. TEMP/TIME adjust button
.
Press this button to set time.
1
.
2
Each time you press the button, the time
moves forward or backward by one minute
depending on which side you press.
The time alters as quickly as you push the
button.
.
Keep pressing the button without releasing,
the time moves forward or backward by 10
minutes depending on which side you press.
2.
CLOCK button
CLOCK
CLOCK
When the right time is achieved, press the
CLOCK button or release the
wait for 5 seconds, the clock time stops
flashing and the clock starts operating.
3.Readjusting the Clock
Press the CLOCK button on the remote
controller for about 3 seconds, the clock
display time will start to flash.
To set the new time, follow 1 and 2 of "Initial
Setting of the Clock".
Note: The time of the CLOCK must be set
before the AUTO-TIMER feature will operate.
If you readjust the time of the CLOCK after
setting the AUTO-ON/OFF timer, the remote
controller will send the readjusted timer
information to the unit.
* Clock accuracy is within 15 seconds per day.
CAUTIONS
Static electricity or other factors (in case of extremely high voltage) can
cause remote controller clock initialize. If your remote controller is
initialized (flashing "12:00"), readjust the clock before you start operation.
5
Forward.
Backward.
or
Automatic operation
1
2
and
When you set the air conditioner in AUTO
mode, it will automatically select cooling,
heating (cooling only type without), or
fan only operation depending on what
temperature you have selected and the
room temperature.
Once you select the operating mode, the
operating conditions are saved in the
unit's microcomputer memory.
Thereafter, the air conditioner will start
operating under the same conditions
when you simply push the ON/OFF
3
button of the remote controller.
Start
Ensure the unit is plugged in and power
is available. The OPERATION indicator
on the display panel of the indoor unit
starts flashing.
1. Mode select button (MODE)
Press to select AUTO.
2. TEMP/TIME button
Set the desired temperature. Normally,
O
set it between 21C /70F to 2 8C /82 F.
3. ON/OFF button
When the remote controller is off,
push this button to start the air
conditioner.
Stop
ON/OFF button
Push this button again to stop the air
conditioner.
If the AUTO mode is uncomfortable, you
can select the desired conditions manually.
When you select the AUTO mode, you do
not have to set the fan speed. The fan
speed will be automatically controlled.
6