Hi-Force HHP30 Petunjuk Pengoperasian dan Keselamatan - Halaman 3

Jelajahi secara online atau unduh pdf Petunjuk Pengoperasian dan Keselamatan untuk Peralatan Industri Hi-Force HHP30. Hi-Force HHP30 4 halaman. Hydraulic hole punch

Halaman Cetak

TDS1312

PREPARATION FOR USE

Refer to figure 2 for identification of parts.

Select the size of punch required based on the hole size that needs to be made

(Refer to Figure 1 for punch / die sizes).

Slacken the die retaining screw in the side of the anvil, and fit the die into the

recess with the identification spot upwards. Tighten the die retaining screw.

Unscrew and remove the locking collar using the tommy bar provided. Fit the

punch into the locking collar in the direction shown in figure 3.

Ensure that the identification spot on the punch is the same colour as that on

the die.

Figure 2. Component Identification (HHP30)

Figure 3. Punch assembly

Page 3 of 4

Rev 2. ECO No. 3890