HI-IQ Products Q-1772-RK Petunjuk Perakitan

Jelajahi secara online atau unduh pdf Petunjuk Perakitan untuk Rak dan Dudukan HI-IQ Products Q-1772-RK. HI-IQ Products Q-1772-RK 3 halaman. Rackmount kit

Halaman Cetak

Websites: www.flatmonitors.com and www.peizen.com

Tool required:

1. No. 2 Phillips screwdriver

2. 3/8" Socket wrench

3. 3/8" Crescent wrench

4. Tie wrap tool

5. Wire cutter, angled tip is recommended

Procedures:

1. It is a good idea to power up and test the monitor before assembling it onto the

rackmount kit, just in case if there is any problem with it (usually very rare).

Otherwise, you may do all the work below and then have to un-do it.

2. If the monitor is working fine, then lay the foam packing material that came in

the box over a flat surface on a table or workbench. The lay the monitor facing

down over the soft foam.

3. Use a No. 2 Phillips screwdriver to remove the monitor from its stand by

removing its four metric screws and washers. Note: Please store the stand and

all the metric screws away in the box the monitor came in. In case of warranty

service, you will need to re-assemble the stand back onto the monitor.

4. Mount the U-bracket onto the monitor with four each 4 mm X 12 mm metric

screws, No. 8 lock washers, and No. 8 flat washers.

PeiZen, Inc.

1227 Flynn Road, Suite 302

Camarillo, CA 93012-6212

Phone: (805) 484-2454, FAX: (805) 383-5909

E-mail:

[email protected]

Assembly Instructions

Q-1772-RK Rackmount Kit

For

of 3